There are numerous network cables for high-end audio on the market that come in a variety of prices, from hard-to-reach prices to affordable ones that are easily accessible. There are good reasons to spend a lot on cables that are as good as their price, but the reality is that there are cables that are somewhat inferior. For this reason, no matter how expensive the cable is, sometimes it is difficult to experience the effect you imagined or expected.
In general, two or three network cables are used to configure a network audio system, and if a system is a bit more complicated, at least 5 to 10 network cables are required. Also, there are situations when the system requires a network cable several meters in length, so you must invest even more.
In all these cases, if you use good and expensive cables for all network paths, you will be able to get great results, but obviously there will be a lot of cost following. For beginners who have limited
experience with a network audio system, it may be a bit difficult to choose an expensive network cable from the start.
So we recommend using the dCBL-CAT7e, which guarantees audio performance beyond the price for any network audio systems.
The dCBL-CAT7e is a high-end performance cable that is easy to access in the price range developed to be used not only for the main network cable for connection to the network player device, which is the most important in the connection of a network audio system, but also for the connection between all network devices.
We proudly announce that the dCBL-CAT7e has the best price and performance, and it will be a solution to the network audio system in various cases.
- Very high price/performance ratio
- Category 7 S/FTP 4 pair cable
- Support 10/100/1000/10G BASE-T (IEEE 802.3)
- 600MHz bandwidth
- High performance CAT.7 connector
- Special noise filter applied
- Very Long length available
Impedance : 100Ω (±5%) @ 100MHz
Support 10/100/1000Base-T, 10GBase-T
Support Category 7 – Verified up to 600MHz
Cable outer diameter : 9mm (±0.5mm)
Gold plated contacts
Nickel plated zinc diecast connector body
Tinned copper braid as overall screening, pair screening with aluminum tape coated film
Lengths from 0.5M up to 50M
Operating & Storage temperature : 0 ~ +40℃